Payment & Shipping Terms:
|Water Basin:||304SS Steel Plate||Shell:||Alum-zink Galvanized Steel Plate (S.Korea)δ=2 Mm|
|Power Supply:||380V/3P/50HZ||Water Eliminator:||Anti-corrosion PVC|
|Spray Pump:||Cast Iron(Schneider)||Temperature Controller:||Standard|
|Fan:||Alum-alloy Blades; Axial Flow||Spare Parts:||As Per Actual Situation|
induced draft crossflow cooling tower,
bac closed circuit cooling tower
Industrial Cooling Coil water Cooling Coil Heat exchange Cooling Coils Evapco Cooling tower Coils BAC Cooling coils:
Advantages for cooling towers
1) Closed loop
Preventing the impurities into the system to block the cooling tubes, soft water is adopted to avoid overheating caused by scaling to the water pipes.
2) Automatic temperature control
Automatic start/stop spraying system to achieve effective control on the temperature of cycled cooling water, the temperature of the cooling water can be controlled below 40 ℃. With this function, the water & energy cost is reduced to the lowest point with intelligent control to the number of working fans and start & stop of spray pump.
3) No need of water pool and cooling tower
Low cost, small space occupancy, easy installation and move with the welder.
4) Automatic digital display of temperature control
Energy efficient and user friendly.
5) Cooling system structure
Galvanized iron beam.
6) High efficiency heat exchange
Four side air inlet louvers supply sufficient amount of wind blowing through cooling coils taking most of the heat away, which effect is strengthened via spray cooling water running through the cooling coils.
7) Small consumption of soft water
Filling the soft water once is enough for half-year operation without water loss.
Antifreeze is required in the winter season for areas subject to freeze temperature.
|Heat Reject :330 kw|
|Gas Filling Rate :35 kg/minute|
|Power of fan :1× 4.0 kw|
|Blowing rate: 1× 65000 m3/h|
|Spray Pump’s Delivery Lift :10 m|
|Spray Pump’s Power : 2.2 kw|
|Spray Water Flow Rate : 44.7 m3/h|
|Drift Loss : 0.01% m3/h|
|Operation Work Pressure: 0.10—0.35 Mpa|
|Inet/ Outnet: 1*DN 100mm/ 1*DN 100mm|
|DN100:Liquid outlet (Please specify adopted screw standards)|
|DN100:Air inlet (Please specify adopted screw standards)|
|Compensation water pipe: DN 25 mm|
|Discharge pipe: DN 50 mm|
|Overflow pipe: DN 80 mm|
|Shipping Weight: 1860 kg|
Contact Person: Peter.Zeng