Payment & Shipping Terms:
|Power Nature:||415V/3P/50HZ||Cooling Coils:||304 SS Cooling Coils|
|Water Basin:||304 SS Steel Plate/Alum-zink Galvanized Steel Plate||Wind Louvre:||Anti-corrosion; Sun Sheltering; Drift Elimination|
|Header Pipe:||Galvanized Steel With Stainless Liner||Electrical Components:||Schneider Brand|
closed type cooling tower,
closed circuit cooling tower
Closed Type Evaporative Condenser Cooling Tower Small Consumption Of Soft Water
1. closed cooling towers are Using the counter flow cooling way; few cooling blind area, high thermal efficiency:
2. Efficiency of cooling tower is to adopt the professional and efficient water collector to control the running floating rate ,that is less or equal to 0.001%;
3.Closed cooling tower in high air duct design to make sure the equipment to meet the demand of cooling air flow rate during operation;
4. Reduce the occupied area compare to other types of cooling tower to meet the users' space demanding;
5. The tank of cooling tower adopts closed loop, eliminate clutters go into the tower body to produce spraying blocked;
6. The important part of counterflow cooling tower is the cooler that uses the antifreeze energy-saving design, to ensure the circulating water drain up and avoid freezing in the northern region with low temperature;
7. Design two-circuit cycle according to the demands of custom's devices, even if one circulation failure, anther cycle can be still normally operating;
8. The cooling tower design of units are elegant appearance, automatic digital display, easy to maintain.
Advantages for cooling towers
1) Closed loop
Preventing the impurities into the system to block the cooling tubes, soft water is adopted to avoid overheating caused by scaling to the water pipes.
2) Automatic temperature control
Automatic start/stop spraying system to achieve effective control on the temperature of cycled cooling water, the temperature of the cooling water can be controlled below 40 ℃. With this function, the water & energy cost is reduced to the lowest point with intelligent control to the number of working fans and start & stop of spray pump.
3) No need of water pool and cooling tower
Low cost, small space occupancy, easy installation and move with the welder.
4) Automatic digital display of temperature control
Energy efficient and user friendly.
5) Cooling system structure
Galvanized iron beam.
6) High efficiency heat exchange
Four side air inlet louvers supply sufficient amount of wind blowing through cooling coils taking most of the heat away, which effect is strengthened via spray cooling water running through the cooling coils.
7) Small consumption of soft water
Filling the soft water once is enough for half-year operation without water loss.
Antifreeze is required in the winter season for areas subject to freeze temperature.
Contact Person: Peter.Zeng